Cutting machine.com

What we can provide

Choice of paper
cutting machine

In view of workpiece

Paper and paper craft

In view of
cutting width

Safety measures and maintenance menu

Key points for extending the service life of the equipment

Operating company

Site map

Inquiries

Inquiries are welcome. Contact us
by phone, by fax,
or by e-mail.

TEL：+81-568-67-5311
FAX：+81-568-68-0495
MAIL：info@itotec.co.jp

Top page ＞ Choice of paper cutting machine ＞ Paper and paper craft


Wood Wood paper for laminated plywood	Wood The material is cork	Felt Honeycomb	Paper and paper craft Paper	Paper and paper craft Packing	Paper and paper craft Twisted paper string ornament	Paper and paper craft Hard press board

Felt Wool felt	Felt Saran rack filter	Felt Cloth felt	Plastic Plastic cardboard	Plastic Polyester film	Plastic Paulownia

Urethane Urethane resin	Urethane Urethane foam	Rubber Rubber	Vinyl Soft vinyl sheet	Glass fiber Glass fiber mat	Metal Metal deposition sheet	PS board PS board mat

Workpiece (material to be cut)：Twisted paper string ornament

Cutting case, company A

Material to be cut：	Material of twisted paper string ornament
Cutting machine：	eRC-137DX

【Key points of cutting】

Material and angle of cutting edge	High-speed steel 24°
Setting method	Material is Japanese paper. Same as paper cutting. Front loading.
Clamp (pressing method)	Press the paper gently with the pedal and cut.
Pressure	25KN
Angle at which the cutting edge is lowered	Standard
Method of clamping the cut material	Immediate release
Others

Workpiece (material to be cut)：Thick paper

Cutting case, company B

Material to be cut：	Thick paper
Cutting machine：	JAC-137NFC

【Key points of cutting】

Material and angle of cutting edge	Ultra fine particle cemented carbide 24° and 22° two-step grinding
Setting method	Same as that of cutting machine. Front loading.
Clamp (pressing method)	Same as paper
Pressure	30KN
Angle at which the cutting edge is lowered	Standard
Method of clamping the cut material	Immediate release
Others

Workpiece (material to be cut)：Particle board, press board

Cutting case, company F

Material to be cut：

Mainly press board type 2 (PB2) is cut. Type 1 is harder.

Cutting machine：

JAC－100CFC
The thickness is 0.18 to 3.2mm. Two sheets are appropriate for the 1.6mm thick 1000mm wide material.
There is no problem with smaller sizes even if the number increases. Moisture can cause variation in the size by about 7mm. An air conditioner controls the humidity.
The error in the lengthwise or transverse size is restricted according to the product. Consideration is taken into for the cutting direction so that the expanding/shrinking direction becomes the orientation that requires no restriction.

【Key points of cutting】

Material and angle of cutting edge	High-speed steel 23°
Setting method	Same as paper
Clamp (pressing method)	Gently press
Pressure	4KN
Angle at which the cutting edge is lowered	Standard
Method of clamping the cut material	Immediate release
Others

Workpiece (material to be cut)：Gasket, packing

Cutting case, company P

Material to be cut：	1800mm-wide packing for prevention of water and oil leaks
Cutting machine：	JAC－160FC

【Key points of cutting】

Material and angle of cutting edge	High-speed steel 24°
Setting method	Same as that of cutting machine. Front workpiece loading
Clamp (pressing method)	Repeat size cutting is made fully automatically. The clamp pedal is not used.
Pressure	25KN
Angle at which the cutting edge is lowered	Standard
Method of clamping the cut material	Immediate release
Others